Clock Hands 3-3/8" Brass Spade (For up to 8" Dial diameter)

How do I choose the right size clock motor & hands? 
1) Refer to the figure here, or Click Here for helpful info (a new window or tab will open)  

2) The size of hands is based on the length of the minute hand from the mounting hole to the end of the minute hand. (Figures 3 & 4) 

3) Our clock motors are sized by the thickness of the dial the movements can go through.  EG. High torque Q-64 will go through up to 5/8" thick material, while standard/mini motor Q-11 will go through 1/8" thick clock faces. (Figure 1 and  item "A" in Figure 2)

Tip 1)  If your material is too thick, consider removing some to in-set the clock.  Or if your clock face material is too thin, consider adding some material behind the face so the hands will sit closer to your clock face. 

Tip 2) Most hands can be slightly trimmed if need be.

Tip 3) Our customers also spray paint them.